Tri Tool 103 REP - Manual (Page 14)

14
TRI TOOL INC.
92-0131 : Rev. 960503
NOTE:
OPERATION USING THE CROSS TRACK ASSY.
Track Positioning with the Locator Tabs
If the Model 512A1 Panel Saw has been used to cut a window in the water wall and the
64” (1.6 mm) Track is still in place than go ahead to ‘Slide the Cross Track Assy’.
INSTALLING THE TRACK ONTO THE WORK.
Bolt a Locator Tab onto the Track at each end perpendicular to the Track.
Bolt a Weld Tab onto both ends of the Track in the next position toward the center from
the Locator tab.
Place the Track on the work.
Line up the Locator Tabs perpendicular to and touching the cut line.
Weld both of the Weld Tabs down. Refer to the picture ‘Weld Tab locations on the
Track’.
Weld Tabs may be rotated as required to make contact with the tops of the tubes.
When welding Weld Tabs to tubes is not permissible, small stacks (not supplied)
may be welded to the membrane and then to the Weld Tabs.
The Weld Tabs do not have to be 90 O to the Track.
Remove the Locator Tabs from the Track.