Tri Tool 103 REP - Manual (Page 15)

15
Model 103 REP TM , Rapid End Prep Machine
92-0131 : Rev. 960503
Weld Tab Locations on the Track
Track Set-up on a Warped Water Wall
Bolt Weld tabs to the Track at the remaining positions, as required.
Weld the Weld Tabs to the work where possible.
Slide the Cross-Track Assy onto the 64” (1.6 m) Track.
It may be required to remove the 23” (.6 m) Track from the top of the Cross-Track Assy
in order to put the Cross-Track Assy onto the 64” (1.6 m) Track.
Remove the two Cap Screws which retain the 23” (.6 m) Track to the top of the Cross-
Track Assy.
LOADING THE MODEL 103 REP TM ONTO THE REP ADAPTOR ASSY.
If the Model 103 REP TM is already loaded into the REP Adapter Assy then go to ‘Slide
the Track Adapter Assy onto the Cross Track Assy’.