Tri Tool 103 REP - Manual (Page 10)

10
TRI TOOL INC.
92-0131 : Rev. 960503
NOTE:
OPERATION
Tool Insert Positioning
Read the operation instructions carefully before attempting to operate the Model 103
REP
TM .
Use eye protection at all times when operating the Model 103 REP TM .
Select the recommended Cutter Head Kit for the outside diameter to be machined.
Refer to the section on Cutter Head Kits.
Select the recommended Pilot Mandrel for the pipe size to be machined. Refer to the
section on Pilot Mandrels.
Pilot Mandrels are recommended based on the inside diameters of the pipe or
tubing to be machined.
For special applications, i.e., very thin wall, extra heavy wall or tough materials, please
contact TRI TOOL Inc. for assistance in the selection.
Attach the cover (part of the Cutter Head Kit) by using the two Button Head Screws
which fit into the slots.
Screw the Cutter Head onto the threaded output shaft of the Model 103 REP TM Rapid
End Prep Machine.
Use the 11/16” Wrenches (supplied) to tighten.