Lowel rifa, Exchange, Accessories – Tiffen Lowel Rifa eXchange User Manual

Page 4

Replacement
Diffusers

Standard light diffuser replacements
for all 4 models of Rifa.
Diffuser must always be used to pro-
tect against lamp explosion.

For LC-44EX
Code: LC-44D
Size: 16 x 16" (40 x 40 cm)

For LC-55EX
Code: LC-55D
Size: 21 x 21" (53.3 x 53.3 cm)

For LC-66EX
Code: LC-66D
Size: 25 x 25" (66 x 66 cm

For LC-88EX
Code: LC-88D
Size: 32 x 32" (81.3 x 81.3 cm)

Rifa Daylight Gel Sets

For correcting Rifas to mix with
varying strengths of daylight,
they attach to Rifa’s velcro pockets
with clothespins.
Each set contains 3 sheets:
Day Blue; 1/2 Blue; & 1/4 Blue
(1 sheet each).

For LC-44EX
Code: LC-47
Size: 23 x 16" (58.4 x 40.6 cm)

For LC-55EX
Code: LC-57
Size: 29 x 22" (73.7 x 56 cm)

For LC-66EX
Code: LC-67
Size: 33 x 26" (84 x 66 cm)

For LC-88EX
Code: LC-87
Size: 39 x 32" (99 x 81.3 cm)

Lowel Rifa

eXchange

Accessories

Light Controls

Soft Egg Crates

For better light control.
Each Egg Crate
attaches quickly
and afterwards
folds up to be
stored in its
own small
light-weight
bag.

30° x 30° Egg Crate

Soft Egg Crate with 30°
dispersion angle.

30° Egg Crate for LC-44EX
Code: LC-44EC/30
Weight: 8 oz (228 g)

30° Egg Crate for LC-55EX
Code: LC-55EC/30
Weight: 9.5 oz (266 g)

30° Egg Crate for LC-66EX
Code: LC-66EC/30
Weight: 12.5 oz (345 g)

30° Egg Crate for LC-88EX
Code: LC-88EC/30
Weight: 1 lb (448 g)

40° x 40° Egg Crate

Soft Egg Crate with 40°
dispersion angle.

40° Egg Crate for LC-44EX
Code: LC-44EC/40

40° Egg Crate for LC-55EX
Code: LC-55EC/40

40° Egg Crate for LC-66EX
Code: LC-66EC/40

40° Egg Crate for LC-88EX
Code: LC-88EC/40

50° x 50° Egg Crate

Soft Egg Crate with 50°
dispersion angle.

50° Egg Crate for LC-44EX
Code: LC-44EC/50

50° Egg Crate for LC-55EX
Code: LC-55EC/50

50° Egg Crate for LC-66EX
Code: LC-66EC/50

50° Egg Crate for LC-88EX
Code: LC-88EC/50

Uni TO Stand

Code: UN-55
Weight: 2.6 lbs
(1.2 kg)

Size: 21.5"
(55.2 cm) folded.
Maximum height:
7' (2.2 m)
Base diameter: 46"
New stand, based on design
combination of Uni-stand &
Omni-stand. More stable than
Uni-stand, more compact than
Omni-stand. For Rifa 44.

KS Jr. Stand

Code: DT-33
Size: Maximum
height: 7'7" (2.3 m),
Collapsed length: 2.3' (65 cm)
Weight: 3.5 lbs (1.6 kg)
Wide based, sturdy, lightweight
stand with 5/8" (1.59 cm)
stud and solid bar legs.
For Rifa 44, 55, 66.

KS Stand

Code: KS
Size: Maximum height:
9' (2.74 m),
Collapsed length:
3' (91 cm)
Weight:
4 lbs (1.8 kg)
Wide based, sturdier, lightweight
stand with 5/8" (1.59 cm) stud.
For all 4 Rifas.

KSA Stand
Code: KSA
Black-anodized, air-cushioned
stand. Otherwise same as above.

Tota-clamp

Code: T1-30
Weight: 4 oz (113 g)
Clamps onto pipes,
shelves, etc. up to
1 7/8" (4.78 cm) thick.
5/8" (1.59 cm) stud locks in two
positions and accepts a light.
Also accepts two Flexi-shafts with
flags or flectors.

Safety Cable (3)

Code: CM-50
Weight: 2 oz (57 g)
Recommended for extra security
when attaching Rifa-lites
|overhead. (Set of 3).

Balance Bar

Code: LC-30
Size: 12.5" (31.8 cm)
Weight: 6.5 oz (184 g)
The Rifa Balance Bar is an extension
arm accessory that mounts between
the Rifa-lite and its stand fitting.
When installed, it can shift the Rifa’s
center of gravity to allow better stand
balance. It can facilitate angling and
tilting of the light when necessary,
such as on a boom arm, without the
need to overtighten stand fitting
knob. Install Balance Bar as shown,
orienting conical washers as
shown (

Mounts

16' Switched AC Cable

Code: T1-80
Weight: 13 oz (369 g)
Standard #18/3; with switch.

10' Unswitched Cable

Code: T1-808
Weight: 1.1 lbs (.5 kg)
For portable stage lighting use.
“Hard service” #18/3 cable.

16' (5 m) Eurocord

Code: T1-801
Weight: 13 oz (369 g)
#18/3 (.75 mm/3) with double pole
switch and male CEE-7 plug.

16' (5 m) T/O UK Cord

Code: T1-802
Weight: 13 oz (369 g)
#18/3 (.75 mm/3) with double
pole switch and male fused BS
1363A plug.

5' Omni 30v Cable

Code: O1-81
Adapts Rifa-44 for use with
30 volt battery #18/3; with switch
and 2 pin “Amphenol Type” connec-
tor for batteries.

4-pin XLR Switched Cable

Code: R2-82
Adapts the Rifa-44
or use with appropriate 12 volt
batteries. No wiring required.

1' 12v Switched Cigarette

Lighter/Car Adaptor Cable

Code: R2-85
Adapts Rifa 44 IEC Connector for
use with some 12 volt batteries and
automobile cigarette lighter sockets.
No wiring required.

Cables

Lowel equipment and kits are sold through authorized Lowel Dealers and, in some countries, Authorized Lowel
Distributors. Repairs, problems, suggestions, and requests for brochures, instructions, parts lists may be handled by
your authorized Lowel Dealer (Distributor) or directly with Lowel. Electrical repairs should be made only by Lowel
or a qualified electrician.

Rifa-lite

, Rifa

, and eXchange

are registered trademarks of Lowel-Light

Manufacturing, Inc. U.S. Patent No. 4594645

90 Oser Avenue, Hauppauge, N.Y. 11788
Call: 800 645-2522 or 631 273-2500
Fax: 631 273-2557
e-mail: [email protected]
www.lowel.com

Problems, info, repairs, etc.

Lowel-Light Manufacturing, Inc.

Male

Female

16'

Male

Female

16'

Male

Female

16'

Female

Male

Female

10'

Female

Male

Female

Male

Rifa Stand-

fitting

Conical

Washers

Rifa

Support

Tube