Teletronics WL11000SA-N - Manual (Page 7)

User’s manual – WL11000SA-N
7
Installation
1. Select the Site - Choose a proper place for your WL11000SA-N Access Point. In general,
the best location to place the access point is at the center of your wireless coverage area,
within line of sight to all your mobile stations.
2. Attach the Antenna - Screw the antenna into the antenna connector (ANT) on the back
panel. Proper placement will improve performance. Try to place the access point in a position
that can best cover its BSS. Normally, the higher you place the antenna, the better the
performance.
3. Connect the Ethernet Cable - The WL11000SA-N can be wired to a 10 or 10/100 BASE-T
Ethernet with a network device such as a hub or a switch. Connect into the RJ-45 connector
socket on the back panel with category 3, 4 or 5 UTP Ethernet cable and an RJ-45 connector.
4. Connect the Power Cable - Connect the power adapter cable to the 9V
DC power Socket on the rear panel.
Warning: ONLY USE the power adapter supplied with the WL11000SA-N.
Otherwise, the product may be damaged.
Note: The RS-232 Port is a reserve port for future function. There is no any
function or configure interface in currently model.