Tech Source Raptor 4000 Series (for Linux) User Manual

Page 37

Raptor 4000 Series: Reference Manual

Part #65-0271-01

The example below represents the resolution set to 1280x1024. In
this case, the X server will automatically select the highest
possible refresh rate for the monitor.

Section "Screen"
Identifier "Raptor4000-0"
Device "Rapafp0"
Monitor "TSI-FP DVI"
DefaultDepth 24
SubSection "Display"
Depth 8
Modes "2048x2048"
EndSubSection
SubSection "Display"
Depth 16
Modes "2048x2048"
EndSubSection
SubSection "Display"
Depth 24
Modes "1280x1024"
EndSubSection
EndSection

If the monitor is not DDC capable, the option

Sync

in the

Device

section should be uncommented so that the digital signal can be
used.

Section "Device"
Identifier "Rapafp0"
Driver "rapafp"
BusID "PCI:41:0:0"
Card "TSI Raptor 4000"
Option "Device" "/dev/rapafp0"
Option "Mode" "mox24"
Option "ScaleCursPos" "on"
Screen 0
Option "Head" "0"
# Option "DDCCheck" "off"
# Option "Rotation" "+r"
# Option "Sync" "sx"
# Option "BackingStore"
# Option "SaveUnder"
# Option "TranspColor" "0x0a3246"
EndSection

NOTE: If the monitor is using an analog signal, the

Sync

option should remain commented out.