Tech Source Raptor 4000 Series (for Linux) User Manual

Page 21

Raptor 4000 Series: Reference Manual

Part #65-0271-01

BusID of

PCI:41:0:0

. If you are

experiencing a problem starting the Xserver,
please verify the BusID of the card in

xorg.conf

match the BusID reported by

the system.

Option "Device": This field specifies the device name assigned

to each head on the Raptor 4000 Series card.
The first head seen by the system will be

/dev/rapafp0

and the second will be

/dev/rapafp1

Option "Mode": This field specifies pixel modes.

8-bit PsuedoColor

24-bit True Color

8+8

Two 8-bit PseudoColor visuals

8+24

8-bit PseudoColor & 24 bit True Color visuals

mox24

MOX, 8-bit Normal, 21-bit Group, 13-bit
Absolute

mox32

MOX, 8-bit Normal, 24-bit Group, 21-bit
Absolute

ScaleCursPos

This Boolean field option is useful when

monitors of different screen sizes are used
together in a multi-screen configuration. When
the cursor crosses screen boundaries, its
position on the new screen will be adjusted to
be proportional to where it was on the
previous screen.

Sync

This field option is used to override DDC info.
The

xorg.conf

resolution line is used to

drive only digital panels. For an analog signal,
this field should be commented out.

TranspColor

This field option is only used while in 8+8

mode. It allows the user to specify the RGB
color values associated with the transparent
color of the overlay. If an application is