Tech Source Raptor DL-Lite Drivers for Solaris - Manual (Page 21)

4-1
Chapter 4
OPENWINDOWS
4.1 Overview
This section describes how to start up OpenWindows on the
Raptor cards. The examples in this chapter use
rapdlt0
as the
device name but the device name of your card may be different
depending on the instance number.
4.1.1 Raptor as the Console
If the Raptor is the console, type:
prompt# openwin
4.1.2 Raptor as the Secondary Framebuffer
If the PGX (Sun Microsystem’s on board video card) card is the
console and the Raptor is the second card, to start OpenWindows
on both cards, in multi-screen mode, type:
prompt# openwin -dev /dev/fbs/m640 \
-dev /dev/fbs/rapdlt0
The assigned OpenWindows screen numbers correspond to the
order of the devices on the command line.
NOTE: In the above example, the
raptor
device instance
number is 0. This may be different in your configuration. Please
check in
/dev/fbs/
or
dmesg
for the correct device instance
numbers on your system.