Tech Source Raptor DL-Lite Drivers for Solaris - Manual (Page 14)

Raptor DL-Lite Drivers for Solaris Installation and Reference Manual
3-4
3.4 Changing Resolution and Bit-Depth
After installation you will need to configure the OpenWindows
screen resolution, bit-depth, and refresh rate for your monitor.
(This resolution is different from the console resolution.
Appendix A discusses the console resolution.) The resolution of
the Raptor DL-Lite card is fixed at 2560x1600 at 60 Hz.
However, at any time after installation you can change the other
parameters by using the
dltconfig
utility.
3.4.1 dltconfig Utility
The
dltconfig
utility has an interactive menu-style interface
(See Figure 3.1). It can be used to set bit-depth and refresh
rate. To use this program to configure your Raptor card, type:
prompt# dltconfig
NOTE: If X Windows is running on the Raptor card(s) to be
configured, please exit out of it before running
dltconfig
.
Failure to do so could result in a corrupted screen for the
remainder of the X Window session.
NOTE: You must be logged in as
root
to execute this
program.