Tech Source Raptor DL-Lite Drivers for Solaris - Manual (Page 12)

Raptor DL-Lite Drivers for Solaris Installation and Reference Manual
3-2
3.3 CD-ROM Installation
The following are step-by-step instructions for installing the
Raptor DL-Lite Drivers for Solaris Software from a CD-ROM.
1.
Install a Raptor card in the computer as described in
Chapter 2.
2.
Boot the computer with the
-r
(reconfiguration) option.
To do this on an UltraSPARC workstation, perform the
following steps:
• Power ON the computer.
• Wait until you see boot messages displaying on the
screen, then press and hold the
Stop
(
L1
) key, and
then press the
A
key.
• At the
ok
prompt, type
boot –r.
3.
After the system comes up, log in as
root.
4. Insert the CD-ROM labeled “Raptor OpenWindows for
Solaris Software” into the drive.
5. If
/cdrom/cdrom0
exists, the CD-ROM was
automatically mounted. Change directories to the CD-
ROM by typing the following:
prompt# cd /cdrom/cdrom0
If
/cdrom/cdrom0
does not exist, mount the CD-ROM
by typing the following: