Tech Source Raptor DL-Lite Drivers for Solaris - Manual (Page 10)

Raptor DL-Lite Drivers for Solaris Installation and Reference Manual
2-2
Step 1: Shut down the system and turn the power OFF. Remove
the system’s cover along with any cables that prevent
you from doing so. Find an available PCI slot, and
remove the bracket and screw. Ground yourself by
touching the metal part of the case.
Step 2: Install the Raptor card firmly into the PCI slot. Take care
to press it evenly and snugly into the slot. Once you are
certain the card is installed properly in the slot, secure it
with the bracket screw.
Step 3: Secure the system’s cover and reattach any previously
removed cables.
Step 4: Connect the Dual Link DVI cable from the Apple HD
panel to the Raptor DL-Lite card.
NOTE: If the system is currently using a secondary TSI graphics
device, read section 3.5 on configuring one of the cards as the
console. The console device is the screen on which the boot up
messages will appear. The monitor must be connected to the
console device before you proceed to the following software
installation chapter.
The Raptor card is now installed and the system is ready for
software installation. Refer to Chapter 3 for instructions on
installing the Raptor DL-Lite Drivers for Solaris software.