Teac CD-200BT - Manual (Page 28)

28
TASCAM CD-200BT
7 – Troubleshooting
If you have problems with your system, look through this
chart and see if you can solve the problem yourself before
calling the nearest retailer or TASCAM representative.
8 No power
e Is the unit’s power plug completely inserted into a working
power outlet?
8 Remote control doesn’t work.
e Check to see if the batteries are properly installed in the
remote control.
e If the batteries are dead, change the batteries.
8 No sound
e Check the connection to the monitor system again.
e Check the volume and settings of the amplifier.
8
There is unwanted noise.
e Are the connecting cables all properly connected and
functioning?
8 A CD cannot be played back.
e If you are using a data CD with MP3 files, confirm that the file
bit-rates are compatible with this unit.
e Is the disc scratched or dirty?
8 I cannot play back all the files on a data CD.
e Make sure the unit is not in folder playback mode.
8
I cannot use program playback.
e Make sure the playback area is not set to ALL PLAY .
To use program playback with data CDs, the playback area
must be set to FOLDER .
8
The audio skips or there is noise.
e Is there a wireless LAN, another Bluetooth device, a
microwave oven or a similar device nearby? Use this unit as
far as possible from such devices.
e Reduce the distance between the Bluetooth device and this
unit when using them together. Try changing the positions
of the Bluetooth device and this unit.
e If you are using any applications on a smart phone other
than one for audio playback, the sound might skip. If this
occurs, stop the operation of applications other then the one
for audio playback.
8
The unit cannot connect to the device or
transmission between them is disrupted.
e Confirm that the Bluetooth device’s power is on and that its
Bluetooth function is also on.
e Is the Bluetooth device too far from the unit? Is a wall or
other obstacle interfering with transmission?
If the Bluetooth device is behind this unit, the unit itself
could be blocking transmission.
Change the positions of the Bluetooth device and this unit.
e Try turning this unit off and than on again.
e Delete the “CD-200BT” pairing from the Bluetooth device
and then follow the procedures in “Pairing” to pair with it
again.
8 Cannot pair with a device.
e Confirm that the Bluetooth device you want to pair with
supports A2DP and AVRCP.
e Confirm that the Bluetooth device you want to connect with
is able to communicate. For details, refer to the operation
manual of that device.
e Turn this unit and the Bluetooth device off once and on
again, and then try pairing them.
e Turn off any other Bluetooth devices other than the one that
you are trying to pair with.
e Delete the “CD-200BT” pairing from the Bluetooth device
and then try pairing again.