Teac CD-200BT - Manual (Page 15)

TASCAM CD-200BT
15
3 – Preparations
Connecting a device to the AUX IN jack
By connecting the audio output of a portable music player or
similar device to the external input (AUX IN) jack, the audio from
that device can be output from this unit’s output jacks. The level
input through the AUX IN jack cannot be adjusted by this unit.
Adjust the output level of the external device.
CAUTION
• Before connecting an external device to the AUX IN jack,
minimize the volume of that device. Failure to do so could
result in sudden loud noises that could, for example, harm
your hearing.
• Before connecting to or disconnecting from the AUX IN jack,
change the current source to something other than AUX IN
(CD or Bluetooth), or turn this unit off.
Preparing the remote control
Inserting batteries
1. Open the lid.
2. Confirm +/- polarity, and insert two AA batteries.
3. Close the lid.
Replacing the batteries
Replace both batteries with new ones when the range of the
remote control becomes short or if the function buttons become
unresponsive.
Cautions about the use of batteries
Misuse of batteries could cause them to leak, rupture or
otherwise be damaged. Please read and abide by the precau-
tions on them when using batteries. Also see “CAUTIONS ABOUT
BATTERIES” on page 4.
Cautions about using the remote control
• When using other devices controlled by infrared rays, use of
this remote control might operate these devices by mistake.
• Use the remote control within the following range.
Remote Sensor
Operation distance
Directly in front: Within 7 meters
15° left or right: Within 7 meters