Super Systems SuperDATA Installation User Manual

Page 8

Super Data Workstation

Page 8

Installation Procedure

3. Copy SDIO.ini and PM6.ini files to the Windows
directory

Open the “Samples” folder in the workstation’s installation location. Since “C:\SSi\” is the default install
location, the folder would be located in “C:\SSi\Samples\”. If the Super Data workstation has been

installed to another location, then the location would be “\Samples\”, where Location> is the location where the software was installed. There should be three files in the “Samples”
folder:



PM6.ini



PM2000DB.ini



SDIO.ini

Copy the “PM6.ini” and the “SDIO.ini” file to the workstation’s Windows directory – C:\Windows or
C:\WINNT (for older versions of Windows).

Step 3 is now complete.

4. Edit the SDIO.ini file and change the reference to all drives from “C” to “S”

Open the “SDIO.ini” file that was copied into the Windows directory and change all references from drive

“C” to drive “S” (or whatever was chosen as the drive letter for the Super Systems Inc computer). Make
the following changes to the file:

Original

New

CONFIGPATH=C:\SSI

CONFIGPATH=S:\SSI

COMMPATH=C:\SSI\comdata

COMMPATH=S:\SSI\comdata

DLOGPATH=C:\SSI\log

DLOGPATH=S:\SSI\log

COMPRESSPATH=C:\SSI\clog

COMPRESSPATH=S:\SSI\clog

DATABASEPATH=C:\SSI

DATABASEPATH=S:\SSI

RTMPATH=C:\SSI\rtm

RTMPATH=S:\SSI\rtm

TRENDPATH=C:\SSI\TRENDS

TRENDPATH=S:\SSI\TRENDS

Note: Make sure that the file that is being edited is in the Windows directory, and not the

“Samples” folder

Step 4 is now complete.

5. Edit the PM6.ini file and change the reference to all drives from “C” to “S”

Open the “PM6.ini” file that was copied into the Windows directory and change all references from drive
“C” to drive “S” (or whatever was chosen as the drive letter for the Super Systems Inc computer). Make
the following changes to the file: