Code composer – Sundance SMT361 User Manual
Page 14
Version 2.7
Page 14 of 23
SMT361 SMT361A User Manual
Code Composer
This module is fully compatible with the Code Composer Studio (CCS) debug
environment. This extends to both the software and JTAG debugging hardware. You
will require updating to version 2.2 or later.
The name of the C64xx CCS device driver is tixds6400.dvr for silicon revision 1.01
and tixds6400_11.dvr for silicon revision 1.1, and should be obtained from Texas
Instruments. In case of difficulty please log onto Sundance’s support forum
WARNING:
From the si
Texas Instrument:
Revision(s) Affected: 1.03 and earlier
Details: The JTAG port does not work properly if non-C64x devices are in the scan
chain with the C64x device.
Workaround: Place all C64x devices in a separate scan chain.
FIRST TIME DOWNLOAD
When you open CCS and want to download an application, after power up, you might
get the following error message:
“Can’t set breakpoint: Cannot set/verify breakpoint at 0x8C40” (the address might be
different)
Workaround: Reset the board first with a server or you should infer a CPU Reset
from Debug\reset CPU. Then you should run the processor.
You can then stop the processor and load your application