Version control, Reprogramming the firmware and boot code, Interrupts – Sundance SMT361 User Manual
Page 11: Communication ports
Version 2.7
Page 11 of 23
SMT361 SMT361A User Manual
Version control
Revision numbers for both the boot code and FPGA firmware are stored in the Flash
ROM during programming as zero-terminated ASCII strings.
The SMT6001 utility is to be used to know the version of the boot code and the
FPGA.
Reprogramming the firmware and boot code
The reprogramming is made using the SMT6001 utility. It comes with the latest
firmware and boot code for the module and with a complete documentation on how to
reprogram a module. It requires only the correct set-up for code composer (see code
composer section).
To confirm that the programming has been successful you should use the Sundance
Server to reset the board and execute the confidence test using SMTBoardInfo.
Interrupts
See general firmware description
Communication ports
The SMT361 provides 4 ComPorts. They are ComPorts 0, 1, 3 and 4.
ComPorts 2 and 5 are interconnected on the module to allow a bypass to the next
module.
See general firmware description