Studio Technologies 5152 V.1 - Manual (Page 19)

Model 5152 User Guide Issue 5, September 2013
Studio Technologies, Inc. Page 19
Model 5152
Video Generator/Audio Embedder Module
EMBED= identifies how audio signals con-
nected to the Model 5152 are being em-
bedded into the SDI output signal. The first
digit represents what happens to the audio
associated with digital audio inputs 1 and 2.
The second digit represents what happens
to the audio associated with digital audio
inputs 3 and 4. Each digit can be either
N, 1, 2, 3, or 4, with N representing no
embedding and the numerical digits repre-
senting an SDI group number.
GPI= identifies how the GPI (general-
purpose input) function has been config-
ured. NA indicates that the hardware ver-
sion of this specific Model 5152 module
does not support the GPI function (applies
to modules with serial numbers 00250 or
less).
DISABLED indicates that the func-
tion is present in hardware but is not active.
EMBEDOFF indicates that the GPI will
control the on/off status of the Model 5152’s
embedder function.
GPO= identifies how the GPO (general-
purpose output) function has been config-
ured. NA indicates that the hardware ver-
sion of this specific Model 5152 module
does not support the GPO function (applies
to modules with serial numbers 00250 or
less).
DISABLED indicates that the func-
tion is present in hardware but is not active.
SDIVALID indicates that the GPO will be
high when a valid SDI signal is connected
to the selected SDI input (coaxial (BNC) or
optical). SDINOTVALID indicates that the
GPO will be high when a valid SDI signal
is not connected to the selected SDI input
(coaxial (BNC) or optical); the GPO will be
low when a valid SDI signal is connected.
EMBEDON indicates that the GPO will be
high when the embedder function is en-
abled. EMBEDOFF indicates that the GPO
will be high when the embedder function is
not enabled; the GPO will be low when the
embedder function is enabled.
STATUS.TXT File – [OPTIONS]
The [OPTIONS] section of the STATUS.TXT
file is provided as a guide when creating
a configuration file (CONFIG.TXT) which
will set the module’s configuration. This
information is provided in the STATUS.TXT
file only as a reference and doesn’t play
an active part in module configuration or
operation.
SDIINPUT= selects which physical SDI
input on the module will be active. BNC
selects the coaxial (BNC) SDI input to be
active. SFP selects the optical SDI input
to be active.
FORMAT= selects the SDI Output Image
Format/Rate Mode. AUTO selects the Auto
Select (Follows Input) mode. LOCKED
selects the Locked (Does Not Follow Input)
mode.
IMGDELAY= selects the interval for the
delay before the stored image is output.
The range is 0 to 7 seconds. A setting of 0
selects no delay. During the delay period
the Model 5152 will output a video image
with a solid-gray color.
MOTION= selects the Moving Image Over-
lay function. OFF disables the Moving
Image Overlay function.
ON enables the
Moving Image Overlay function.
SDIMODE= selects the SDI Mode function.
NORMAL selects that a valid SDI signal
connected to the selected SDI input will
pass through to the module’s SDI output(s).
REFONLY selects that the selected SDI
input will serve only as a timing reference
signal. In this latter mode, the internally-
generated image will always be sent to the
SDI output(s).