Studio Technologies 780-03 V.4.15 - Manual (Page 35)

Model 780-03/790 User Guide Issue 1, April 2015
Studio Technologies, Inc. Page 35
for Surround
Press and hold both the LFE Low-Pass and Dim buttons for 5 seconds to
restore Model 780-03 and Model 790 factory defaults. Once defaults have been
restored, the associated LEDs will light. After the buttons are released, configu-
ration mode will be exited and normal operation will resume. See Note below.
Configuration—Restore Factory Defaults
Factory Defaults:
Device address A1.
Stereo input sample rate converter enabled.
Bass management disabled.
Bass management low-pass filter slope 24 dB-per-octave.
Bass management high-pass filter slope 24 dB-per-octave.
Bass management crossover frequency 80 Hz.
Sync source is L/R of currently selected input.
Sync input terminated.
Audio-synced-to-video sample rate 48 kHz.
Reference level set for –60.0 dB post-fader monitor
output level.

Warning: Each Model 790 unit must have a unique address. Restoring factory defaults will reset only this specific
Model 790 to device address A1. If another connected unit is already configured for address A1, normal
system operation will stop.
Note: The 5-second button-press delay is a safety feature ensuring that the factory defaults will not be accidently
restored.
Attenuation display mode selected.
85.0 dB SPL reference level.
Auto reference level off disabled.
–20 dB dim level.
Remote mute all enabled.
Remote dim enabled.
LFE downmix level full attenuation when To Stereo or
To Mono downmix functions active.
Pre-fader monitor outputs pre-downmix.
Input delay 0 milliseconds for both A and B.
0.0 dB post-fader monitor output level offsets.