Spohn FT-607 - Manual

Spohn Performance, Inc.
494 E Lincoln Ave Myerstown, PA 17067
1-888-365-6064 www.spohn.net
Part# FT-607 – Rear Upper Control Arms
1972-1976 Ford Torino & Ranchero
USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER’S DISCLAIMER OF WARRANTY!
By their very nature, competition components are constantly pushed to their limits. While our
components are designed to withstand intense race conditions, it is impossible to control the
quality of installation or the varying conditions in which they are used. It is for this reason that
absolutely no warranty or guarantee is either written or implied. Neither the seller nor the
manufacturer will be liable for any loss, damage, or injury – direct or indirect – arising from
the use of or inability to determine the use of any product. Before using, the user should
determine the suitability of the product for its intended use, and the user shall assume all
responsibility in connection therewith. Spohn Performance, Inc. makes no guarantee as to the
legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it intend its
products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to
make changes in design or add to or improve on their product without incurring any obligation
to install the same on product previously manufactured. The Buyer agrees to indemnify and
hold Spohn Performance, Inc. harmless from any claim, action or demand arising out of or
incident to the Buyer’s installation or use of products purchased from Spohn Performance, Inc.
INSTRUCTIONS
1. Lift rear of vehicle and support with jack stands on the frame rails. DO NOT
SUPPORT BY REAREND!
2. Place the jack underneath the rear axle to support, but do not lift.
3. Remove both bolts and nuts and remove the stock rear upper control arm. The
axle will shift slightly rearward (Remove and replace one UCA at a time).
4. Install the Spohn control arm using the jack to help position the rear axle
properly. The poly bushing goes to the front and the arm should bend down and out.
Use the supplied spacers on either side of the Del-Sphere end (The UCAs ship with
the bushing and spacers wire tied in place so you know how they are to be installed).
Tighten the front bolts to 110 ft/lbs. and the rear bolts to 72 ft/lbs.
5. Safely lower the vehicle to regular ride height.
1