beautypg.com

Spohn 736 User Manual

Spohn performance, inc

background image

Spohn Performance, Inc.

494 E Lincoln Ave Myerstown, PA 17067

1-888-365-6064 www.spohn.net

Part #736 – Rear Coil Over Kit

1982-2002 GM F-Body

USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER’S DISCLAIMER OF WARRANTY!

By their very nature, competition components are constantly pushed to their limits. While our components

are designed to withstand intense race conditions, it is impossible to control the quality of installation or
the varying conditions in which they are used. It is for this reason that absolutely no warranty or

guarantee is either written or implied. Neither the seller nor the manufacturer will be liable for any loss,
damage, or injury – direct or indirect – arising from the use of or inability to determine the use of any

product. Before using, the user should determine the suitability of the product for its intended use, and
the user shall assume all responsibility in connection therewith. Spohn Performance, Inc. makes no

guarantee as to the legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it
intend its products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to

make changes in design or add to or improve on their product without incurring any obligation to install
the same on product previously manufactured. The Buyer agrees to indemnify and hold Spohn

Performance, Inc. harmless from any claim, action or demand arising out of or incident to the Buyer’s
installation or use of products purchased from Spohn Performance, Inc.

INSTRUCTIONS

1. Lift the carpet inside the vehicle enough to gain access to the top shock mount

through the floor pan. Disconnect the vehicle’s battery (due to welding).

2. Raise vehicle and support with stands. Place a floor jack under the rear housing to

allow lifting and lowering of the rear housing.

3. Remove rear wheels.

4. Install coil over shocks one side at a time. Disconnecting both rear shocks at the
same time will cause the rear end housing to be very unstable!

5. With the rear supported by the floor jack, disconnect one rear shock and remove
it completely from the vehicle. Remove the stock coil spring.

6. Install the top reinforcement plate. Placement will be self explanatory, you want to
line up the hole in the plate with the shock mounting hole in the floor. Mark where

your welds will be around the plate edges and around the i.d. of the plate cut out in
the area of the stock spring seat. Remove the plate and sand the paint/dirt from the

floor pan where the welds will be placed. Re-install the reinforcement plate, place a
bolt and nut through the shock mounting hole to hold the plate firmly in place for

welding. Weld the reinforcement plate into place using a MIG welder. Paint the plate
and weld area.

7. Install the coil over shock as assembled to the bottom rear housing shock mount
using the supplied clevis mount, bolts, washers, and nuts.

1

Table of contents