Spohn 993 - Manual (Page 2)

2
15. Tighten the four transmission crossmember bolts to the car
16. Position the driveshaft loop so it is centered on the driveshaft and hold it in that
position
17. Tighten the two 7/16” bolts into the transmission mount
18. You may have to put a slight bend on the catalytic converter floor mounted heat
shield to allow proper loop to shield clearance on some cars.
19. You now have an NHRA legal driveshaft safety loop on your vehicle.
USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER’S DISCLAIMER OF WARRANTY!
By their very nature, competition components are constantly pushed to their limits. While our components
are designed to withstand intense race conditions, it is impossible to control the quality of installation or
the varying conditions in which they are used. It is for this reason that absolutely no warranty or
guarantee is either written or implied. Neither the seller or the manufacturer will be liable for any loss,
damage, or injury – direct or indirect – arising from the use of or inability to determine the use of any
product. Before using, the user should determine the suitability of the product for its intended use, and
the user shall assume all responsibility in connection therewith. Spohn Performance, Inc. makes no
guarantee as to the legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it
intend its products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to
make changes in design or add to or improve on their product without incurring any obligation to install
the same on product previously manufactured. The Buyer agrees to indemnify and hold Spohn
Performance, Inc. harmless from any claim, action or demand arising out of or incident to the Buyer’s
installation or use of products purchased from Spohn Performance, Inc.
DRILL HOLES TO 7/16"