Soundtube FP6020-II - Manual (Page 5)

FP-ScentAir™ (with motion sensor)
Module Description
The FP-ScentAir™ ships
pre-plumbed for use with a
ScentAir device. ScentAir unit is
sold separately and must be
purchased through an
authorized ScentAir reseller.
The FP-ScentAir includes the
FP-Motion module as a trigger.
To adjust the motion sensor
refer to the FP-Motion
installation instructions.
Section 1 - ScentAir
Connection
Connect the ScentAir
Connect ScentAir unit to
FP-ScentAir plumb tube [1] with
ScentAir unit installation
instructions. Once
programmed, the FP-ScentAir
will release a scent when
motion is detected.
Section 2 – Optional
Amplification
The FP-ScentAir can be used
with the FP-Amp. To incorporate
the FP-Amp, refer to those
instructions.
Power External Controller LED Light
Amp Control
Speaker
Contact closure = Green/White
Contact closure = Green
12 V trigger = Blue/White
Amp control = Blue
LED control = Orange/White
LED control = Orange
Amp gain = Blue
Amp gain = Orange
Left in = White
Left in = Green
Right in = Red
Right in = Black
Power = Brown/White
Power ground = Brown
Cat 5 Wiring
All signal and control wires are located in the signal/hanging cable provided
with the FP unit speaker wires. A Cat 5 cable (blue shield) contains the control and power
wires; audio wires are individual 16-gauge wires in the bundle.
Audio relay
(ships with motion sensor)
Wiring Instructions
1 FP-ScentAir module
1 FP-Motion module
5 Pair audio relay jumpers
Contents
FP pod
Motion sensor trim pot
(delay off timer)
Pod cover
ScentAir plumb tube [1]
Motion sensor module
Motion sensor
wide aperture
Motion sensor narrow aperture
Main electrical board
Motion sensor connection
FP modules ship pre-installed
from the factory.
Other FP Series optional
modules include:
1. LED Light
(not available with FP ScentAir)
2. Amp
All modules require a power source.
An optional 15-volt source is
available from SoundTube
(Model numbers: AC-PS-1530
or AC-PS-1550).
Pod cover screws
FP Series
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
Warning
© 2010 SoundTube Entertainment, Inc. All rights reserved. PN INS-FP-SCENTAIR Rev04.02.10
Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
1.435.647.9555 | 800.647.TUBE | www.soundtube.com
435.647.9555 | 800.647.TUBE | www.soundtube.com
Install Instructions For:
FP-ScentAir™ (with motion sensor)
FP Series
435.647.9555 | 800.647.TUBE | www.soundtube.com
Install Instructions For:
FP-ScentAir™ (with motion sensor)
FP Series