SoundTraxx SoundCar Users Guide - Manual (Page 25)

Tsunami SoundCar User’s Guide Page 21
Setting Directional Control
CV 57 (FX5, FX6 Directional Control Enable) is used to configure the
directionality of the FX5 and FX6 function outputs. FX5 directionality is
controlled by bits 0 (forward) and 1 (reverse), and FX6 is controlled by bits
4 (forward) and 5 (reverse). Setting a bit to 1 enables the corresponding
function in the specified direction. Either function may be made bi‑directional
by setting both the forward and reverse bits to 1.
CV 58 (FX5, FX6 Lighting Override Enable) is used to configure FX5 or
FX6 so that all other lighting function outputs automatically turn off when
the corresponding function is turned on. This is ideal when you need to
use the lighting function to activate an emergency light for simulating a red
signal when a stalled locomotive is occupying the mainline. In this case, the
emergency light would be turned on and all other lights would be turned off.
Basic Programming