SONOSAX SX42 - Manual (Page 19)

SX42 User's Manual Page 19 of 26
GREEN: when the Limiter is active.
RED: when an audio signal is close to overload (6dB before clipping).
NOTE: There are three levels of LED’s light intensity that will depend on the amount of
detected daylight. Thus, if more daylight is detected LED’s light intensity will be
increased.
4.4.13 Output rotary faders (L & R)
These two rotary potentiometers (faders) allow you to progressively adjust the desired audio
level of the corresponding output channel (L & R), within a wide level range going from -
∞ to
+10dBu.
4.4.14
Talkback push buttons (L & R)
When these push buttons are depressed the signal of the selected internal source (the talkback
microphone or the oscillator) is fed to the corresponding output channel.
4.4.15
Battery test (BATT)
When this push-button is depressed, the needle of the right level meter will indicate the average
voltage per battery cell (minimum: 1V, maximum: 1.6V). In case of use with an external power
supply, the meter will indicate the voltage divided by four. For instance: a 1.5V indication means
that the external voltage is equal to 6V DC.
4.5
Bottom Panel