SONOSAX SX42 - Manual (Page 16)

SX42 User's Manual Page 16 of 26
NOTE: The use of these high quality limiters helps you to avoid the overload of the output or
your recorder input. Where stereo balanced limiting is needed use the LINK position.
4.3.11
Master levels link (LINK R to L)
This switch allows you to link the Right output channel level control (rotary fader) to the Left
output channel level control. Thus, you only need to adjust the level control of the Left output
channel to set the audio level of both output channels (L & R).
ACCESSORIES SECTION
This section describes all settings available for the optional internal modules.
4.3.12
Accessories power (OFF ON)
This switch allows you to turn ON or OFF the power of any internal accessory located inside the
mixer, for example a HF transmitter.
NOTE: If the mixer is turned OFF, the accessory power is also turned OFF even if the ACC
POWER is ON.
WARNING: The internal power supply will provide to the accessories a maximum current of
200mA under 9V DC and/or a maximum current of 200mA under 5V DC.
4.3.13
ACC 1 switch (OFF ON)
This two position switch has no particular function. It has been intentionally left free for a later
use with an internal accessory. Feel free to connect it according to your needs.
4.3.14
ACC 2 switch (OFF ON)
This two position switch has no particular function. It has been intentionally left free for a later
use with an internal accessory. Feel free to connect it according to your needs.
4.4
Front Panel
The front side of the SX42 includes all the figures used during the shooting, and all the
monitoring functions.
4.4.1
Input rotary faders (IN1 to IN4)
These four rotary potentiometers (faders) allow you to progressively adjust the desired audio
level of the corresponding input channel (IN1 to IN4), within a wide level range going from -
∞ to
+10dBu.