SOMFY SONESSE 50 RTS - Manual (Page 4)

4
© 2013 Somfy SAS. All rights reserved. 04/2013
EN
1) Slide the motor into the tube.
For smooth roller tubes, position the notch previously
cut on the crown.
2) Fix the tube to the drive whell with 4 self-tapping
screws with a diameter of 5 mm or 4 steel pop rivets
with a diameter of 4.8 mm located at L - 15 mm ± 3 mm.
Warning: The screws or pop rivets must only be
attached to the drive wheel and not to the motor.
If necessary, screw the bracket interface on the motor
head.
1) Mount the motorized tube on the end bracket (c).
2) Mount the motorized tube on the motor bracket (d).
Fit the stop ring (e).
a
b
Ø>47mm
c
d
e
e h
e
h
a
b
Ø>47mm
c
d
e
e h
e
h
a
b
Ø>47mm
c
d
e
e h
e
h
a
b
Ø>47mm
c
d
e
e h
e
h
3.3. Motor/tube assembly
3.4. Mounting the motorized tube on the brackets
4. WIRINg
1) Cut off the mains power supply.
2) Connect the motor according to the
information in the table below:
3 x 0.75 mm 2
3 x 1,5 mm 2
1
2
3
RANGE Neutral Live Earth
230V-50Hz Blue Brown Yellow/
Green
220V-60Hz
120V-60Hz
White Black Green
100V-50/60Hz
4.1. Power wiring