SOMFY SONESSE 50 RTS - Manual (Page 2)

2
© 2013 Somfy SAS. All rights reserved. 04/2013
EN
CONTENTS
1. Introduction 3
2. Safety 4
2.1. Safety and responsibility 4
2.2. Specific safety advice 4
3. Installation 5
3.1. Motor preparation 5
3.2. Tube preparation 5
3.3. Motor/tube assembly 5
3.4. Mounting the motorized tube on the
brackets 5
4. Wiring 6
4.1. Power wiring 5
4.2. Data wirirng 5
5. Commissioning 7
6. Operation 8
7. Troubleshooting 9
8.1. Question on the Sonesse ® 50 RS485 or
LT50 RS485? 9
8. Technical data 9
1. INTROduCTION
The Sonesse ® 50 motor range can motorise all tubular applications: Roller shades, Roman shades,
Projection screens, ...
The Sonesse ® 50 is designed to ensure quiet operations.
The Sonesse ® 50 RS485 & LT50 RS485 are digital AC motors, compatible with RS485* solutions
(*physical layer).
The Sonesse ® 50 RS485 & LT50 RS485 motors are designed to be connected on a BUS Line
RS485.
Somfy hereby declares that this product conforms to the essential requirements and other relevant provisions of
Directive 1999/5/CE. A Declaration of Conformity is available at www.somfy.com/ce. Usable in EU, CH and NO.
Images are not contractually binding
2. SAfETy
2.1. Safety and responsibility
• This Somfy product must be installed by a professional installer of motorisation and home automa-
tion, for whom these instructions are intended.
• Before installation, check that this product is compatible with the associated controls and accesso-
ries (crown, wheel brackets).
• These instructions describe how to install, set and use this product.
• Moreover, the installer must comply with current standards and legislation in the country in which
the product is being installed, and inform his customers of the operating and maintenance
conditions for the product.
• Any use outside the application scope specified by Somfy is not approved. Such use, or any
failure to comply with the instructions given herein will invalidate the warranty, and Somfy refuses
to accept liability.
Subject to technical modifications.