Smithco Spray Star 1760 (Sn 176G012 – Current) Parts & Service Manual - Manual (Page 10)

Ser
vice
8
7. After drilling, position a chisel across the hole and
strike sharply to break the ring. Replace with a new
retainer ring when reassembly. 8. Support the axle shaft assembly in a suitable press.
Press on the end of the axle shaft until the wheel
bearing and brake assembly is removed.
1. Inspect the shaft for possible damage. In the following
order, place new oil seal, brake assembly, new grease
packed bearing assembly (with unit bearing rib ring
toward fanged end of shaft) on the axle shaft. The
retaining ring will be placed on the shaft later. 2. Support the bearing assembly in a suitable press.
3. Press assembly until bearing is firmly seated against
axle shaft shoulder. 4. Slide new retaining ring on the axle shaft and support
the shaft in suitable press.
AXLE SHAFT DISASSEMBLY
(CONTINUED)
AXLE SHAFT ASSEMBLY