Smithco Spray Star 1750D (sn 175D180 – Current) Parts & Service Manual - Manual (Page 84)

82
Accessories
17-506 FRESH WATER TANK DRAWING
REF# PART# DESCRIPTION QUANTITY
1 HB-516-18-075 Bolt 5 /
16
- 18 x 3 /
4
4
HW-516 Washer 5 /
16
4
HWL-516 Lock Washer 5 /
16
4
2 15-750 Tank Mount Bracket 1
3 HB-38-16-275 Bolt 3 /
8
- 16 x 2 3 /
4
2
HNFL-38-16 Flange Lock Nut 3 /
8
- 16 2
4 10-234 3 Gallon Rectangular Tank 1
10-234-01 Lid 1
5 16-158 Close Nipple 3 /
4
x 3 /
4
1
6 16-960 Spigot 3 /
4
NPT 1
7 16-151 Elbow FPT 3 /
4
x 3 /
4
1
1. Fresh Water Wash Tank mounts on the left side of the Roll Bar just above the sprayer control valve.
2. Clamp the mount bracket to the roll bar post approximately 19" up from the mount foot and then mark the
holes onto the tube with a center punch. Drill the two holes using a 3 /
8
drill bit.
3. Secure the bracket to the post with two 3 /
8
x 2 3 /
4
bolts and flange lock nuts. Then tighten.
4. Install the nipple (Ref 5), elbow (Ref 7) and spigot (Ref 6)into the bottom of wash tank (Ref 4). Use thread
tape on all threads.
5. Mount the tank onto the mount bracket (Ref 2) using four 5 /
16
x 3 /
4
bolts, washers and lockwashers.
TIghten.
6. Rinse tank with clear water and check for leaks around fittings.
This tank is for fresh clear water ONLY. Do not put chemicals in this tank.