Smithco Spray Star 1750D (sn 175D180 – Current) Parts & Service Manual - Manual (Page 74)

72
Accessories
1752 (RAVEN 440 ) HOSE REEL PLUMBING
REF# PART# DESCRIPTION QUANTITY
1 15-743 Electric ball Valve 1
2 15-742 Inlet Cover 1
3 15-740 50 Series Clamp 3
4 15-748 Reducer Coupling 1
5 15-736 #50 Elbow Coupling 1
6 15-738 Flanged Ball Valve 1
7 15-749 Hose Barb 1
INSTALLATION INSTRUCTIONS
1. On the top of the Electric Spray Control Valve (Ref 1) you will find a cover. Remove clamp, o-ring and
cover. Install a 15-748 reducer (Ref 4) in place of the cover you just removed. Reinstall clamp and o-ring
and tighten. The cap will not be used again.
2. Install a 15-736 Elbow onto the top of the reducer with a 15-740 clamp (Ref 3) and O-ring. Rotate it 90° so
it points to the rear of the machine, then tighten clamp.
3. Install the 15-738 ball valve (Ref 6) onto the elbow using a 15-740 clamp and O-ring. Tighten with the
handle on the top or side.
4. Install the 15-749 Hose Barb (Ref 7) onto the open end of the ball valve with a 15-740 clamp and o-ring.
Tighten.
5. Route the orange 3 /
4
" hose fro the hose barb to the hose barb on the hose reel and secure with a 18-040
Hose clamp.
6. Secure the orange hose to the machine with a nylon tie strap.