Smithco Tournament Roller 7530 Operator Manual - Manual (Page 15)

CONTROLS, INSTRUMENTS & START UP FOR 7555
IGNITION SWITCH
Located on the right hand side of the steering colum. This is a two-position ignition switch;
Stop
– Start.
A. Fuse & Fuse Holder: Under seat cover.
STEERING
Acquaint yourself with steering before operating machine. The automotive type steering wheel is
connected to the roller assembly by a chain driven sprocket. This allows for quick turns and
short turning radius.
SEAT ADJUSTMENT
Seat adjustment lever is located under front of seat on left side. It provides seat adjustment
forward or backward for operator’s comfort.
FOOT PEDALS FOR 7555
RIGHT FOOT PEDAL
The right foot pedal is used for going to the right. When the pedal is released the roller will come
to a slow stop.
LEFT FOOT PEDAL
The left foot pedal is used for going to the left. When the pedal is released the roller will come to
a slow stop.
START UP
1. Make sure the master switch is turned on. The driver must be in the seat to start up.
2.
Pedals must be in “Neutral”.
3. Make sure the brake switch is in the “ON” position, located on the right hand side.
4. Turn the key switch to the “ON” position.
5. Turn the brake switch to the “OFF” position. The gauge located on the left hand side
should show “Ready”
6. If the gauge is flashing Red, the start-up procedure was incorrect. Try the start-up
procedures again.
13