Smart Avi Net-IP-Pro - Manual (Page 5)

5 © 2013 SmartAVI, Inc.
CONNECTING TO THE NET-IP-PRO
After connecting the NET-IP-PRO to the network and plugging in
the power supply, you will need to find the IP address in order to
connect to it. This can be done with either of the following two dis-
covery tools. The first, called “detect” will open up a small console
application that will display the IP address of the NET-IP-PRO. Af-
ter obtaining the IP address connect to the device with the web
application of your choice by typing that IP address in the web
browser or connect through telnet on port 23. An alternative op-
tion is to use “detect_gui,” this program will find the IP address of
the NET-IP-PRO and then open up a web browser to the NET-IP-
PRO web interface. The steps to do this are shown below.
1. Power off all devices.
2. Using a CAT5 cable, connect the NET-IP-PRO to your local network.
3. If you have a smart-AVI device use your RS-232 male to male
cable to connect the NET-IP-PRO to your smart-AVI device.
4. Plug the power into the NET-IP-PRO.
5. Use one of the discovery tools (mentioned above) to connect
to the NET-IP-PRO web interface or telnet application.