Dymo LT100-H - Manual (Page 4)

4
To insert the batteries
1. Remove the battery compartment
cover. See Figure 2.
2. Insert the batteries following the
polarity markings (+ and –).
3. Replace the cover.
Remove the batteries if the label
maker will not be used for a long
period of time.
Connecting the Optional Power Adapter
An optional 9 Volt, 1.5 A power adapter can also be used to power
the label maker. Connecting the AC adapter to the label maker
disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top of
the label maker.
2. Plug the other end of the power adapter into a power outlet.
Make sure the label maker power is turned off before you
disconnect the power adapter from the main power source.
Otherwise, your most recent memory settings will be lost.
Figure 2
!
!