Sierra Video RTR-804 - Manual (Page 8)

SIERRA VIDEO
2
Warnings & Safety Regulations
The information in the following section provides important warnings and safety
guidelines for both the operator and service personnel. Specific warnings and cautions
may be found throughout this manual. Please read and follow the important safety
precautions noting especially those instructions relating to risk of fire, electrical shock and
injury to persons.
Any instructions in this manual that require opening the equipment cover or enclosure are
intended for use by qualified service personnel only. To reduce the risk of electrical
shock, do not perform any servicing other than what is contained in the operating
instructions unless you are qualified.
Warnings
 Heed all warnings on the unit and in the operating instructions.
 Disconnect AC power before installing any options.
 Do not use this product in or near water.
 This product is grounded through the grounding conductor of the power
cord. To avoid electrical shock, plug the power cord into a properly wired
receptacle before connecting inputs and outputs.
 Route power cords and other cables so that they are not likely to be
damaged, or create a hazard.
 Dangerous voltages exist at several points in this product. To avoid personal
injury, do not touch unsafe connections and components when the power is
on.
 To avoid fire hazard, use only the specified type, correct voltage, and
current rating of fuse. Always refer fuse replacement to qualified service
personnel.
 Have qualified personnel perform safety checks after any completed service
 This is an FCC class A product. In a domestic environment, this product
may cause radio interference, in which case the user may be required to take
necessary measures.
Cautions
 Use the proper AC voltage to supply power to the switcher. When installing
equipment, do not attach the power cord to building surfaces.
 To prevent damage to equipment when replacing fuses, locate and correct
trouble that caused the fuse to blow before applying power.
 Use only the recommended interconnect cables to connect the switcher to
other frames.
 Follow static precautions at all times when handling the equipment.
 Leave the side, top, and bottom of the frame clear for air convection cooling
and to allow room for cabling. Slot and openings in the frame are provided
for ventilation and should not be blocked.
 Only an authorized Sierra Video technician should service the switchers.
Any user who makes changes or modifications to the unit without the
expressed approval of the Sierra Video will void the warranty.