Sierra Video RTR-804 - Manual (Page 28)

SIERRA VIDEO
22
"T": Trigger a Salvo Connect Sequence
From Syntax Description
Host T reg
Trigger a list of connect commands stored in a
salvo register.
Router (None)
The command "T" is used to trigger a previously set up salvo (set using the "P" command above).
It must be followed by a register letter from A to Z or a register number from 1 to 256 giving the
register to be triggered.
For example, the command:
** TB D180 TC !!
says to trigger salvo register B (same as 2), delay 180 sync intervals, then trigger salvo register C
(same as 3). When the register is triggered, this means that the connect commands stored in it
take effect.
If a salvo is triggered and it attempts to connect a locked output or port, or a disallowed
input/output pair, or a port to itself, the salvo trigger operation is aborted, no crosspoint changes
are performed, and an error is reported: "ERROR Salvo Has Locked Xpts".