Hardware configuration – Sensoray 7429 User Manual
Page 11

HARDWARE CONFIGURATION
D
EFAULTS
The 7429 requires installation of programming shunts to select various options such as
I/O port addresses, interrupts, and individual channel filters. This chapter describes
these configuration options.
After configuring the option shunts, the sensor coprocessor may be installed in you
STDbus backplane and programmed as explained in the next chapter.
Defaults as shipped from the factory
Command/Data port
B2H
Status port
B3H
I/O space
primary
Data available interrupt
disabled
Alarm interrupt
disabled
STDbus interrupt enable
disabled
Individual channel filters
disabled
I/O S
PACE
Two separate I/O spaces exist on the STD bus: primary and expanded. Option jumper
E21 selects which I/O space the 7429 board will reside in.
Install E21 to map the board into primary I/O space, or remove E21 to map the board
into expanded I/O space. E21 is factory set to map the board into primary space.