Sea Eagle Hybrid SUP (HB96) - Manual (Page 8)

Locate a relatively
clean area that is free
of sharp objects.
Unpack your Sea Eagle
SUP from the bag and
lay it out flat.
Insert the pump hose
with the recessed valve
adapter into the valve
and turn clockwise to
lock into place and then
beging pumping.
The pressure gauge
will not begin to register
until the board begins
to get pressurized.
Pump until the working
pressure of between 12
and 15 PSI is reached.
Do not exceed 15 PSI
when inflating.
Skegs
Three skegs are in-
cluded with the board.
Any combination of
skegs can be used in-
serted into the bases
on the underside of the
board.
Slide the skeg into the
base and secure with
the clip. If a skeg will
not slide into its base,
do not force it. Refer to
instructions page 11.
The bases have strings
attached so the skegs
can be tied to the
board.
Stand Up Paddle
This three-part paddle
has a T-handle, shaft
and blade. Insert the
blade into the shaft and
align the hole with the
button to lock in place.
Insert the T-handle and
adjust to the desired
length using the locking
nut.
Carbon Fiber SUP
(OPTIONAL)
This three-part paddle
has a carbon fiber T-
handle, shaft and blade
section. Insert blade
into the shaft and align
the hole with button.
Insert the T-handle and
adjust to the desired
height. Lock with the
thumb lock.
Paddle Pocket
The paddle pocket at
the front of the foot
pad. Insert the blade
when carrying the
board or walking into
the surf.
7
Hybrid SUP | ASSEMBLEY & INFLATION ASSEMBLEY & INFLATION