Sea Eagle FoldCat (375FC) - Manual (Page 9)

Once the oarpins are in-
serted place, lock them
in place using the slide
rings as shown.
375FC Motormount
Includes a motor mount
block, two L-brackets,
two short and two long
bolts, knurled knobs
and washers.
Secure the L-brackets
to the motor mount
block using the long
bolts. Orient the block
so it hangs about 1/2”
below the floorboard.
Then use the short bolts
to secure the mount to
the floorboard.
To prevent cavitation
when using a short
shaft gas motor. The
completed setup should
hang slightly below the
floorboard, as shown.
Tighten the knurled nuts
and bolts before secur-
ing a motor.
Casting Bar
(OPTIONAL)
Adds safe and secure
support for stand-up
casting and doubles as
a convenient hand-hold
while stepping aboard.
Includes crossbar with
padded cover, two
upright leg bases, and
two 4mm hex keys (one
spare).
Insert the uprights into
the crossbar. The height
of the casting bar can
be adjusted to one of
three positions using
the pre-drilled holes on
the uprights.
Before attaching the
casting bar to your boat,
make sure that the
FoldCat’s pontoons are
partially deflated. Insert
the upright bases over
the underbars in the
bow and tighten the set
screws at the base
using the hex key.
Paddling Life Vest
(OPTIONAL)
U.S.C.G approved! This
type III PFD is great for
all boating needs and
gives you plenty of arm
room in case you feel
like rowing. Comes in
various sizes with three
adjustable buckles and
adjustable nylon straps
for a tight secure fit.
8