Sea Eagle FoldCat (375FC) - Manual (Page 7)

Select a flat space that
is free of any sharp ob-
jects and unroll the boat
hull so that it is laid out.
Please note that the
aluminum floorboards
have been pre-installed,
but can be adjusted if
necessary.
Stabilizer Underbars
Each FoldCat comes
with aluminum stabilizer
underbars. From the
bow, slide one underbar
under both the first and
second floorboards.
Align the ends of the
underbars in line with
the triangular markings
on each pontoon.
When properly aligned,
the underbars should
line up underneath the
center floorboard.
Once they are in place,
finish inflating the boat
to full capacity.
Assembly & Inflation
Swivel Seat
The 375FC has two
basic seating positions
with one at the rear and
the other at the front.
Quick release-a-seat
mount comes with four
bolts and four wing
nuts. You’ll need a
Phillips head screw-
driver (not included) to
complete installation.
The mount can remain
attached when being
folded for storage and is
a one-time assembly.
Position the mount over
the pre-drilled holes
designated for it and
bolt the mount to the
floorboard using the
bolts and wing nuts.
Now slide base of the
the swivel seat (or base
of the pedestal if you
are using it as shown)
into the mounts. Make
sure that the spring
loaded lever mecha-
nism locks into place.
6
ASSEMBLY & INFLATION