Sea Eagle FoldCat (375FC) - Manual (Page 8)

Pedestal
(OPTIONAL)
The pedestal is included
in several FoldCat boat
packages and includes
four 1/2” bolts and four
wingnuts. The 375FC
can be fitted with up to
two pedestals.
NOTE: Make sure that
all hardware is secured
tightly before every use.
Bolt the upper end of
the pedestal directly to
the bottom of the swivel
seat. Slide the other
end of the pedestal into
the release-a-seat
mount and check to
make sure that the
spring loaded lever
mechanism is locked.
Scotty Baitcaster
(OPTIONAL)
Holds a bait caster reel
in a cushioned cradle.
Slot in the front allows
for a spinning reel to be
securely held in place.
Includes side/deck
mount. You will need a
Phillips Head screw-
driver (not included).
Begin by installing the
deck mount onto the
bases. Be sure the
“logo” on the mount
reads upright when
looking from inboard be-
fore securing the mount
with the provided
screws.
Next, install the rod
holder into the base by
pushing the post
straight down into the
mount. Line up the
notch at the base of the
rod holder with the key
in the mount and insert
it firmly into place. The
rod holder can be ro-
rated in its base by lift-
ing and turning.
Oars & Oarlocks
Each oarlock includes
one oarlock pin, two
bolts, two knurled knobs
and two washers. First,
attach the oarlock to the
middle floorboard.
Bolt the raised oarlock
bases at both ends of
the aluminum bench
through the pre-drilled
3/8" holes (2 at each
end) using knurled nuts.
Slide the oarlock pin
over the shaft of the
oars, snap the oars
shafts together and then
insert the oarlock pin
into the top of the oar-
lock. Tighten the clamp
with the wingnut.
7
OPTIONAL ACCESSORIES