Scotsman RS160 - Manual (Page 23)

REMOVAL & REPLACEMENT
To Replace Vend Switch:
1. Disconnect Electrical Power.
2. Lift up and pull out and remove upper front
panel.
Lever Type Actuation:
A. Twist ice chute 1/3 turn and pull down to
remove.
B. Remove screws holding valve mounting plate to
cabinet. Pull valve and plate assembly out and
away from cabinet. Switch is mounted to valve
plate.
Reverse steps to reassemble.
Push Button Actuation:
Locate vend switch behind push button assembly
of upper front panel.
3. Remove wires from switch.
4. Remove screw and nut retaining switch to
mounting plate, and remove switch from dispenser.
5. Reverse steps to reassemble.
To Replace Gear Motor Assembly:
1. Disconnect electrical power.
2. Remove cover from hopper.
3. Unscrew sweep arm holding rotor to gearmotor
shaft.
4. Remove rotor from gearmotor shaft.
5. Remove splash panel.
6. Remove upper panel.
7. Twist ice chute 1/3 turn and pull down to remove.
8. Remove ice chute mounting plate.
9. Remove screws holding valve mounting plate to
cabinet. Pull valve assembly out and away from
cabinet.
10. Mark location of gearmotor bracket on
cross-brace.
11. Disconnect gearmotor electrical leads in
control box
12. Remove (4) screws holding gearmotor bracket
to cross brace.
13. Pull gearmotor & bracket from cabinet.
14. Remove bracket from gearmotor.
15. Reverse to reassemble. Gearmotor bracket
should be installed where it was, so that the rotor
should clear bin surface by 1/8" to 1/4". If needed,
the slots on the gearmotor bracket will allow the
position of the rotor to be adjusted.
Electrical Shock Hazard.
Unplug unit before
servicing.
Light Tube
RS160 and RS220
June 1995
Page 23