Scotsman CS55 - Manual (Page 17)

Spray Platform and Spray Jets
1. Open ice bin door.
2. Pull out on the left side and remove
curtain assembly.
3. Lift the spray platform up and pull out to
get to the water hose at the base of the
platform.
4. Pull hose off of connection to spray
platform, and pull platform from ice maker.
5. Unscrew nozzle caps from the spray
platform, check for spinner discs, clean or
replace the spinners.
6. To replace, reverse the removal
procedures.
Water Inlet Valve
1. Unplug the icemaker to disconnect
electrical power.
2. Shut off water supply to icemaker.
3. Remove the lower back panel, pull out to
expose inlet water valve.
4. Disconnect electrical wires from inlet
water valve.
5. Disconnect water lines to and from water
valve.
6. Remove valve from icemaker.
7. Reverse removal procedure to replace.
Water Pump
1. Disconnect ice maker from electrical
power.
2. Remove top panel.
3. Open ice bin door pull up through top
and remove.
4. Remove curtain by pulling forward and
out on the left end..
5. Pull out spray platform, and disconnect
hose.
6. Remove screw from water pump cover.
7. Pull top of water pump cover forward,
and then pull water pump up and out of ice
maker.
8. Dismount water pump from cover
assembly, and remount the replacement
pump in its place, including water
discharge hose.
9. Reverse the balance of the steps to
reassemble.
CS55 REMOVAL AND REPLACEMENT
December, 1987
Page 16
WATER PUMP COVER CURTAIN
PULL OUT
INLET WATER
VALVE
WATER PUMP
ASSEMBLY
ELECTRICAL
CONNECTIONS