Scotsman CD200 - Manual (Page 9)

ON-OFF
Switch
Vend Switch
Hopper
Sink
Start Up
Always check the installation before beginning a
start up. Do not start up a machine until it has
been properly installed.
1. Start up the ice machine, following the directions
given in the manual packed with the ice machine.
2. Allow the ice machine to make several batches
of ice, so the dispensing mechanism can be tested.
3. Locate the sink key, and remove the sink
assembly by pulling the bottom away from the
dispenser, then pulling the sink down.
4. Check that the ON-OFF switch is in the ON
position.
5. Return the sink assembly to its normal, locked
position.
6. Push the vend switch in (units without coin or
key mechanisms) to start the dispensing cycle. Ice
will fill the hopper and the rotating wheel inside the
dispenser will stop.
7. Push the hopper down to release the ice.
8. Repeat step 6, but this time push the hopper
down during the dispensing process, the process
should stop. Release the hopper and dispensing
should continue. If not, remove the sink and check
the action of the safety switch at the top of the sink
assembly.
9. Pour water in the sink area to check for proper
drainage.
10. Give the sink key to the owner/user and inform
them about the operation and maintenance of the
machine.
CD200
January 1996
Page 10