Warning, Troubleshooting, Service – Royal Vacuums UR30085 User Manual

Page 31: Problem possible reason possible solution

5. troubleshooting

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the

checklist below.
Any other servicing should be done by an authorized service representative.

WARNING

To reduce risk of personal injury - unplug vacuum before servicing.

problem

possible reason

possible solution

Cleaner won’t
run

1. Not firmly plugged in

1. Plug unit in firmly

2. No voltage in wall receptacle

2. Check fuse or breaker

3. Blown fuse or tripped breaker

3. Replace fuse or reset breaker

4. Thermal protector activated

4. Allow cleaner to cool for 30 minutes (this will

reset the thermal protector)

Cleaner/ tools
won’t pick up

1. Broken or worn belt

1. Replace belt

2. Agitator brushroll worn

2. Replace brushroll

3. Filter bag full

3. Change filter bag

4. Incorrect carpet height setting

4. Move nozzle control knob to lower setting

5. Blockage in air flow passage

5. Clear blockage

Cleaner hard to
push

1. Incorrect carpet height setting

1. Move carpet height control to a higher setting

6. serViCe

ANY OTHER SERVICING SHOULD BE DONE BY AN

AUTHORIZED SERVICE REPRESENTATIVE

to locate a dealer near you, visit our website at www.royalvacuums.com or call

Customer Service at (1-800-321-1134)

In the event that further assistance is required, see your Yellow Pages for an authorized Royal

Dealer. Costs of any transporta-

tion to and from any place of repair are to be paid by the owner. The service parts used in this unit are easily replaced and read-

ily available from an authorized Royal

Dealer or retailer. Always identify your cleaner by the model number and manufacturing

code when requesting information or ordering replacement parts. (The model number appears on the bottom of the cleaner.)