Royal Vacuums UR30085 - Manual (Page 15)

8
To move your cleaner
from room to room, put
handle in upright
position, tilt cleaner back
on rear wheels and push
forward.
transporting Cleaner
The cleaner can also be
moved by using the carry
handle.
Carry handle
The handle of your
cleaner has three
positions; upright for
storage and when using
cleaning tools; operating
position for general
operation on carpet and
floors; low for reaching
under low furniture. Step
on handle release lever
to lower handle.
handle positions
2.4 2.5
2.6
Cleanseeker™
With red and green lights (A),
the ‘CLEANSEEKER’ system
alerts the user to areas of
carpet that may need more
cleaning attention. It is able
to sense when larger
amounts of dirt particles,
especially embedded dirt,
are removed.
To let you know that the
CLEANSEEKER™ feature is
ready, the red light will come
on when the cleaner is first turned on. After a few
seconds, the red light will go off and the green light will
come on. Cleaning may then begin.
The green light will remain on throughout cleaning except
when the detector senses that a larger amount of dirt is
being picked up; then the red light will come on.
When the red light is on, you should take additional
cleaning strokes in the area until it changes to green.
• The red light may seldom come on during cleaning. This
means that your cleaner is picking up primarily fine
surface dust and lint which the system may not detect, or
that the carpet is generally clean. To increase the feature’s
sensitivity to dirt, set the switch (B) to the “Hi” position.
• At other times, the red light may stay on for a considerable
amount of time. This means that the carpet contains a
high level of dirt which is being removed by the cleaner.
To decrease the feature’s sensitivity to dirt, set the switch
to the “Reg” (Regular) position.
2.7
A B
Carpet height adjustment
The cleaning of carpet
and rugs takes place at
the nozzle (A).
When it is necessary to
raise and lower the
nozzle for various carpet
pile heights, slide the
nozzle control knob (B)
to the desired setting.
2.8
A
B
handle position
For ease in sliding knob,
the handle should be in
the upright position (C).
The nozzle will not move
into the adjusted position
until the cleaner handle is
lowered to the operating
position (D).
2.9
C
D
Cord storage
Wrap cord on cord hooks for
convenient storage.
Attach the plug end to the cord.