Royal Vacuums UR30085 - Manual (Page 10)

1. VaCuum assembly
5
A. Handle Section
B. Cleaner Body
C. Hose, Cleaning Tools and Wands
D. Hose Rack
E. Handle Bolts and Nuts Packet
(in bag with owner’s manual)
Remove all parts from carton and identify
each item shown.
Make sure all parts are located before dis-
posing of packing materials.
1.2 Open tool cover on handle section (A).
1.3 Attach hose rack to handle section by fitting hooks (B)
on rack over slots (C) on handle section.
1.4 Align hole on rack with circular tab on handle.
1.5 Remove bag door on cleaner body by pushing down
at top of door and pulling door outward.
Switch (A) above bag door should be in OFF
position.
1.6 While holding rack in place, slide handle onto cleaner
body.
Make sure tab is inserted fully into slot.
1.7 Push bolts into holes on back of handle.
1.8 Place nuts in recessed areas on front of handle. Hold
each nut in place while tightening each bolt securely with
a Phillips screw driver.
1.9 Reposition bag door by fitting tabs on bottom of door
into opening. Press top of door to snap securely shut.
1.10 Press cord into the 3 notches and the clip as
shown.
attaCh raCk and handle
Carton Contents
1.1
A B
D
1.3
1.4 1.5
1.2
C
E
A
B
C
A
CAUTION
! !
To reduce the risk of personal injury, unplug vacu-
um before assembling.
1.6 1.7
1.8 1.9 1.10