Completing the installation – RLE F110 Quick Start User Manual
Page 2
© Raymond & Lae Engineering, Inc. 2011. All rights reserved. RLE
®
is a registered
trademark and Seahawk™, Falcon™, and Raptor™ are trademarks of Raymond &
Lae Engineering, Inc. The products sold by Raymond & Lae Engineering, Inc. are
subject to the limited warranty, limited liability, and other terms and conditions of sale
set forth at http://rletech.com/RLE-Terms-and-Conditions.html.
5144
3/2011
104 Racquette Drive
Fort Collins, CO 80524
970.484.6510
www.rletech.com
3
Left-click on the F110 that needs to be modified.
4
Click the Set IP button.
5
In the pop-up box, enter the IP address provided by your IT
administrator.
Notes:
a
If you are configuring the F110 for a DHCP network, enter 0.0.0.0.
b
If you need to change the subnet mask or default gateway, click the
Settings button, press enter when prompted for a user name and
password, and change the subnet mask and default gateway on the
Network Settings web page that displays. Click the Accept Changes
button when done.
4
Completing the Installation
Once the Falcon F110 has been detected, you can configure it using the Web
interface:
1
View the Web interface by typing http://
browser. Use the IP address you assigned to the F110.
2
Click the Settings button to display and change the configurable settings
of the F110.
Note: You do not need to enter a user name or password. When
prompted for these, press Enter on your keyboard.
For configuration details, see the F110 User Guide at
http://www.rletech.com
.