beautypg.com

Completing the installation – RLE FDS-Wi Quick Start User Manual

Page 2

background image

©2010 RLE Technologies. All rights reserved. RLE is a registered trademark, and
SeaHawk, Falcon, and Raptor are trademarks of RLE Technologies. All other
trademarks or registered trademarks are the property of their respective companies.
Although the information contained in this document is believed to be accurate and
correct, RLE Technologies assumes no responsibility, and disclaims all liability, for
any damages resulting from the use of this information or any error or omission in this
document. RLE Technologies does not warrant, guarantee, or make any
representations as to the performance, fitness for use, safety, or reliability of any
existing or future wiring, equipment, additions or modifications to equipment, or any
other component of the original or modified system. Specifications are subject to
change without notice. Part number 10065 Rev. 2.0 6/2010

104 Racquette Drive

Fort Collins, CO 80524

970.484.6510

www.rletech.com

2

Reset the computer to its original IP address and subnet mask.

Note: This step might require assistance from your IT administrator.

The computer and the FDS-Wi are now both configured to communicate
on the network.

3

Connect the computer and the FDS-Wi to the network.

4

From the computer’s Web browser, go to the new IP address of the
FDS-WI.

5

When prompted, enter the user name and password to verify network
access to the FDS-Wi.

If the login window for the FDS-Wi does not display:

a

Verify that the cables are firmly attached.

b

Verify that you entered the correct IP address for the FDS-Wi.

c

Check for activity on the Link and Active LEDs on the front of the FDS-
Wi as follows:

If the Link LED is off, the FDS-Wi is not connected to the network.
Check the cable connections.

If the Active LED is on solid, too much data is being sent to the
FDS-WI for it to process. Consult your IT administrator.

4

Completing the Installation

As shown in the screen shot above, the Configuration page is made up of five
submenus. These submenus allow you to:

Enable/disable antennas

Set network and Web properties

Adjust the date

View system information

Set up BACnet

Set Modbus properties

Adjust SNMP properties

Exit to the bootloader

Restore factory defaults

Delete all sensors

For details, see the FDS-Wi Wireless Gateway User Guide at

http://www.rletech.com

.