RGBLink MSP 209 User Manual - Manual (Page 6)

MSP 209 User Manual RGB-RD-UM-M207E001 3
5.0 Installing the Converter
1. Attach fiber cable from the Converter to the fiber network.. The fiber connections must
be matched: transmit socket to receive socket.
2. Attach a UTP cable from the TP network device to the RJ45 port on the Converter.
3. Connect the power cord to the Converter and check that the Power LED lights up. The TP
Act and FX Act LEDs will light when all the cable connections satisfactory.
6.0 Technical Specifications
The Converter conforms to the following standards:
Standerds: IEEE 802.3z/AB 1000Base-T
1000Base-SX/LX
UTP Cable: Cat.5e or Cat.6 cable and up to 100m.
Fiber Cable:
1000SX: 50/125，62.5/125μm molti-mode
1000LX: 9/125μm single-mode.
Data Transfer Rate:
2000Mbps for full-duplex at 1000Mbps speed.
LED Indicators:
TP TX,RX, , 100, 1000
Power, FX LINK
TP Flow Control: NWay auto-negotiation
Fiber Flow Control: NWay at full-duplex mode
Power Requirement: 5VDC，2A
Ambient Temperature: 0 ～ 50℃
Humidity: 5% ～ 90%
Dimensions：26×71×93mm（H×W×D）