beautypg.com

RGBLink MSP 219 Quick Start User Manual

Quick start, View size the world, Msp 219

background image

MSP 219 –

Quick Start

SDI Input

Power Indicator

Power Interface

Interfaces

Output Interface

1

2

3

SDI Output

Power Interface

SDI Input

Connect one end of the power adapter with the device,
the other end into a socket. Plug in, red power indictor
light means the device works normally.
The device uses the standard 12V/3A power supply.

1

4

~

Power Indicator

The red power indicator is on when device has power
supply.

Interface Description

Input and Power Interface

Can receive signal from HD player and HD
camera.

SDI Output

Can connect the next level device with SDI
interface.

MSP 219-2

MSP 219-4

SDI Output

1 2

Functional Description Block Diagram

Input and Output Resolution

NOTE

This quick start provides basic instructions for an experienced

installer to set up and operate the MSP 219.

For full installation, configuration, and operation details, please refer to
the MSP 219 user manual, which is available at www.rgblink.com.

VIEW SIZE THE WORLD

Common Questions and Solution

Power indicator light is off or blinks

1. Check whether plug in the power cord, and has
power supply;
2. Check whether the power cable is connected, and
in good connection;
3. If above without problem, then the power
indicator is damaged.

MSP 219 Quick Start

Rev 1.0

Page 1 of 1

Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected]

http://www.rgblink.cn

12V power interface poor contact

1. Check whether the power interface is in good
connection, if the interface is not tighten, screw
it again.
2. Check whether any problem with adapter head,
replace it if there is any problem.
3. Check the power connector is loose, if so, please
send to professional personnel for repair.